LMR-195 50 Ohm Coaxial Cable Assemblies with N Connectors
LMR-195 50 Ohm Coaxial Cable Assemblies
LMR-195 coaxial cable assemblies provide a compact and flexible solution for connecting antennas and radio-frequency equipment. With a nominal characteristic impedance of 50 ohms and professional N-type RF connectors, these cables offer practical interconnections for wireless communication, telecommunications and radio installations.
The LMR-195 cable construction combines flexibility with controlled RF transmission performance, making it suitable for short antenna feeders, equipment jumpers and connections where installation space is limited.
N-Type RF Connector Configurations
The illustrated LMR-195 cable assemblies feature two connector arrangements: N male to N male (Nm–Nm) and N male to N female (Nm–Nf). These configurations provide connection options for antennas, radio transmitters, receivers, RF instruments and other equipment using compatible 50-ohm interfaces.
Professional RF Applications
LMR-195 coaxial cables can be integrated into VHF and UHF radio installations, FM radio equipment, GSM, UMTS and LTE antenna connections, as well as RF measurement and monitoring systems.
Cable selection depends on the operating frequency, transmission power, required length and connector interfaces. RF attenuation increases with both cable length and frequency, making appropriate cable routing and connector selection important considerations for reliable system performance.
For information about LMR-195 coaxial cable assemblies, connector terminations and available configurations, please contact PROTEL with the required connector combination, approximate cable length and intended operating frequency.
Frequently Asked Questions
What is LMR-195 coaxial cable used for?
LMR-195 is a flexible 50-ohm RF cable type commonly used for antenna jumper assemblies, equipment interconnections and short coaxial feed runs.
What impedance does LMR-195 have?
LMR-195 has a nominal characteristic impedance of 50 ohms, matching the impedance used by many professional antennas, radios and RF instruments.
Which connector combinations are shown on this page?
The illustrations show N male-to-N male (Nm–Nm) and N male-to-N female (Nm–Nf) cable assemblies.
Can LMR-195 be used with GSM, UMTS and LTE antenna systems?
Yes. LMR-195 can be used in compatible 50-ohm RF connections for these systems when the frequency, cable attenuation, power and connector interfaces meet the installation requirements.
How should the cable length be selected?
Choose the length needed for the physical route, allowing for correct installation and connector access. A longer cable introduces greater RF attenuation, particularly at higher frequencies.
How can I request information about an LMR-195 assembly?
Use the AntennaKit contact form and specify the connector types, required length and operating frequency so that the requested configuration can be assessed.